Solar shower accessories

Try to seal the connections with Teflon tape.

The connections will be damaged if tools are used, so please assemble the parts hand tight. The screw connection is already tight before it is completely screwed in. This allows
correct positioning, so that the shower head points downwards. If screw connections are not tight or the position is not correct, wrap the thread with Teflon tape.

The entire body of the shower is filled with water and works similarly to an electric boiler, where the heated water also collects at the top. When hot water is needed, cold water is let in by operating the faucet at the bottom of the tank, and the hot water already heated in the upper part is pressed out of the tank. After closing the faucet, the water from the shower head is still running. This circumstance is due to the heating of the water in the unpressurized tank and causes the dripping of the shower head. This is not a defect! A 3-4 minute after-dripping is therefore possible. If your shower drips longer or more strongly, please contact our helpdesk.

No, the shower is not frost-proof. Please disassemble the shower and remove all water from the pipes and the tank as soon as the outside temperature drops below 10 ° C. The shower must be stored in a dry, frost-proof room.

It is technically unavoidable for limescale to precipitate in the tank, which can block the shower head.
The shower head can become blocked by limescale. To avoid damage, the shower head must be
should be checked regularly and cleaned if necessary. This is necessary at the latest when the flow rate from the shower head is significantly reduced.

Procedure:

• Dismantle the shower head
• Rinse out the tank by operating the shower without the shower head for approx. 2 minutes
• Descale the shower head with a commercially available bath cleaner
• Install the shower head