Steinbach
Solar cover reels stainless steel for pools up to 5 m wide
- Movable stainless steel roller mount
- Select up to 5 m width with telescopic aluminium extension
Sold Out
The selected product is currently not available. As soon as the product is on stock, we will send you an E-mail.
Product information
Movable rewinding unit for solar covers for tanks up to 5 m width.
- Plastic hand wheel
- Extendible aluminium shaft
- Stainless steel substructure
- For pools up to 5 m width
- Movable
FAQs for Solar cover reels stainless steel for pools up to 5 m wide:
With this solar cover reel, the solar cover is connected to the aluminum shaft using rubber bands. For this to work, the solar cover must have eyelets on one narrow side. If this is not the case, it can be retrofitted with plastic eyelets at any time. There are plastic eyelets in the well-stocked hardware store. A connection without plastic eyelets is not possible, otherwise the solar cover will tear open.
The solar cover retractors are only suitable for pools that are fully sunken into the ground. They are installed by fixing them to the ground, which is why these retractors cannot be used for above-ground pools or pools that are only partially sunken.
In connection with this roll-up device, eyelets must be placed in the solar cover. These eyelets should always be mounted on the short side. E.g. for a solar tarp for an 8 x 4 m pool, the eyelets are mounted on the 4 m side.
FAQs from category Solar covers:
With this solar cover reel, the solar cover is connected to the aluminum shaft using rubber bands. For this to work, the solar cover must have eyelets on one narrow side. If this is not the case, it can be retrofitted with plastic eyelets at any time. There are plastic eyelets in the well-stocked hardware store. A connection without plastic eyelets is not possible, otherwise the solar cover will tear open.
The side with the air knobs must be on the surface of the water.
The production size of a solar cover corresponds to the size that is placed on the water surface of the pool. Therefore, the production dimensions of the solar cover may differ from the installation dimensions of the pool. Pay attention to the production dimensions of the solar cover. If the solar cover is too large, it can be cut to size manually.
No, due to the sun's rays and the lack of cooling by the water, the air knobs can burst.
With the straps and plastic plates included in the scope of delivery, the solar cover is directly connected to the retractor. This allows any type of solar cover to be attached. The solar tarp can be reinforced on the fastening side, but this is not mandatory. The distance between the straps and the retractor must be long enough for the solar cover to lie completely on the water surface when unrolled.
Unfortunately we do not offer custom-made products.
Solar covers utilise the power of the sun in an intelligent way. With a special bubble cover, they heat the bathing water by 3 to 5 degrees. The start and end of the bathing season can thus begin several weeks earlier or end several weeks later.